12
HAMA_DP2_UM-20151116-EN
EN
5 OPERATION
5 OPERATION
Introduction
This chapter provides information about operating the HAMA Duo-Power 2.0 in the plaster
application version as well as the skim coat version.
Safety
• All safety markings and hazard designations on the machine must be
clearly visible throughout the service life of the machine.
• Only people who have been trained specifically for this are permitted
to operate the machine.
• Because compressed air and aggregate hoses could get bent over
sharp edges, serious damage could occur that can result in physical
injury. Hoses with kinks in them must be replaced immediately.
• Air hoses and aggregate hoses that are to be opened or uncoupled
must be depressurised first.
• Persons rectifying blockages in an aggregate hose and spraying tools
(spray gun) must make sure that they and bystanders are not sprayed
with outgoing aggregates.
• Wear ear protectors. Working with the repair gun or being present in
the immediate vicinity of repair work may lead to hearing damage.
• Wear eye protection (safety goggles). The air pressure may cause
small hard or liquid particles to deflect off the wall causing damage to
eyes.
• Wear a gas mask. Most plaster products contain solvents. This could
cause dizziness or even unconsciousness.
• The HAMA Duo-Power 2.0 must be connected to a 230 V wall socket
with earth connection and must be fused for 16 A. If no wall socket
is available in the immediate area of the workplace, no more than
one fully extended extension reel or extension cord with an earth
connection and a minimum core thickness of 2.5 mm
2
may be used.
Safety devices both on the outside of the machine and in the
hopper must be present and intact at all times as they where during
commissioning. In the event of damaged or lost safety devices, the
machine must not be used until it has been restored to its original state.
