10
13. More settings
13.1 Time / date settings
•
Press [ ] and navigate to the menu item "System".
•
Select "Time" and confirm by pressing [
OK
].
•
Choose between „Set time/date” and „Auto update time”
and confirm by pressing [
OK
].
Set Time/ Date
Manually set the time (
hh:mm
) and date (
DD-MM-YYYY/
MM-DD-YYYY
) using [
Volume -/+
] and [
OK
].
Autoupdate
• Update from FM / Update from DAB
If automatic time and date adjustment is activated,
the device receives time and date information from the
station over the FM/DAB/DAB+ radio network. This is
the best way to ensure that the clock will run accurately
and the alarm will trigger at the correct time, even after
power outages.
• Update from Any
It is recommended to use this setting (Update from
FM and DAB) for the automatic update.
• No update
The time and date (
DD-MM-YYYY/MM-DD-YYYY
)
must be set manually; no automatic calibration
takes place.
13.2 Backlight
Manual settings
The backlight can be configured for each operating mode
(Operation Mode, Standby Mode) separately.
Proceed as follows:
•
Press [ ] and navigate to the menu item "System".
•
Select "Dimmer" and confirm by pressing [
OK
].
•
For the operating modes (
In Operation
) and standby
mode (
Standby
), select between various brightness
levels.
•
When the radio is in standby, press [
] to illuminate
the display at the brightness level set for that operating
mode for approx. 10 seconds.
Automatic settings (Sensor)
With the sensor enabled, the backlight is automatically
adjusted to the environment and its brightness. In complete
darkness (for example, at night in the bedroom), the
backlight completely turns off.
To deactivate the automatic setting (sensor), proceed
as follows:
•
Press [ ] and navigate to the menu item "System".
•
Select "Dimmer" and confirm by pressing [
OK
].
•
Select "Automatic dimmer" and then the required setting.
Note
When the sensor is activated, selected settings are not
taken into consideration under the Standby mode and
Operating mode menu items.
