7
8.4.1 Save presets
Set the station that you would like to save as a station
preset.
If the station is received, proceed as follows:
•
Press and hold [ ] until the Presets list opens.
•
Navigate to the preferred memory slot and confirm your
selection by pressing [
OK
].
•
The selection will be confirmed by the display showing
"Program (1-7) saved".
Note
It is not possible to delete a preset station. You can
only replace a preset station with another station and
overwrite the previous favourite.
8.4.2 Retrieving presets
Proceed as follows to open the overview with the station
presets:
•
Press [ ] to call up the Presets list.
•
Navigate to the preferred station and confirm your
selection by pressing [
OK
].
8.5 DRC (Dynamic Range Control)
Some DAB network radio stations support a volume control
feature that actively takes effect during playback. If the
volume suddenly increases, DRC automatically lowers it. If
the volume suddenly becomes quieter, DRC automatically
raises it. The same happens when playback is suddenly
quiet. The radio then increases the volume again.
DRC high:
total equalisation of different volumes. Strong compression
can audibly reduce the dynamics of a music title.
DRC low:
partial equalisation of different volumes. More subtle
compression, without too much loss of dynamics.
DRC off:
no equalisation.
Proceed as follows to do the settings:
Note
By default, DRC volume adjustment is disabled.
•
Press [ ] and navigate to the menu item "DRC".
•
Confirm your selection by pressing [
OK
].
•
Select the required option and confirm it by pressing [
OK
].
9. FM
Repeatedly press [
M
] to enable
FM
operating mode
on the radio:
9.1 Search setting
The search setting allows you to determine whether
stations with low signal strength are ignored during
the automatic search.
Proceed as follows:
•
Press [ ] to access the "Search settings" menu item.
•
Confirm your selection by pressing [
OK
].
•
Pressing [BACK] takes you back to the playback screen.
•
Select "Strong stations only" in order to only stop during
the automatic search on stations with a strong signal.
Otherwise, the search run will stop at every station for
which a signal is received.
Note
By default, the "Strong stations only" method is selected.
Select
Strong stations only
to stop only on stations
with a strong signal in the automatic search. Otherwise
(
All stations
), the search will stop at every station
for which a signal is received.
