6.1 Mounting on the wall
6.1.1 Preparing the intended mounting surface
Get support and help from other people for the following assembly steps.
•
First use the bracket as a template and re-measure if necessary to ensure that the position is correct. Use a
spirit level to check the horizontal and vertical alignment of the bracket on the wall. Now mark the holes on
the wall.
8 mm
60mm
Ø8mm
A2 A3
A1
•
To attach the wall bracket to the wall, you need a drill and a drilling attachment with a diameter of 8mm.
Make sure that the drilling attachment is suitable for the intended wall. The depth of the hole should be
60mm
.
•
To ensure a secure hold, vacuum out the drill holes with a vacuum nozzle so that the drill hole is free of drill
dust. Now insert the plug [A2] into the drill hole so that it is flush with the hole.
•
Ensure that the top screw (A1) with the washer (A3), as shown above, is not screwed all the way in. The screw
should project from the wall by around 5 to 8 mm (the wall bracket will be hung on this screw in the next
step).
