Copyright © 2023 Halogen Systems, Inc. All rights reserved worldwide.
ii
Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user
’s authority to operate the
equipment. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at their expense. The following techniques can be used to reduce interference problems:
1.
Disconnect the equipment from its power source to verify that it is or is not the source of the interference.
2.
If the equipment is connected to the same outlet as the device experiencing interference, connect the equipment to a different outlet.
3.
Move the equipment away from the device receiving the interference.
4.
Reposition the receiving antenna for the device receiving the interference.
5.
Try combinations of the above.
DECLARATION OF CONFORMITY
Drinking Water Sensors are Tested and certified to NSF/ANSI/CAN 61 and 372
–
2020
Certificate date issued: 7/23/2021
120VAC Displays Also Tested and Certified to:
Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory Use; Part 1: General Requirements>Valid without technical
revision: 01Jan2022< [UL 61010-1:2012 Ed.3+R:16Nov2018]
Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory Use - Part 2-081: Particular Requirements for Automatic and
Semi-Automatic Laboratory Equipment for Analysis and other Purposes [UL 61010-2-081:2019 Ed.3]
Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory Use Part 1: General Requirements>Valid without technical
revision: 23Oct2019< [CSA C22.2#61010-1-12:2012 Ed.3+U1]
Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory Use - Part 2-081: Particular Requirements for Automatic and
Semi-Automatic Laboratory Equipment for Analysis and other Purposes [CSA C22.2#61010-2-081:2019 Ed.3]
Manufacturer’s Name:
Halogen Systems, Inc.
Manufacturer’s Address:
8985 Double Diamond Pkwy Suite B10, Reno, NV 89521
Type of Equipment:
Multiparameter Sensor and Display
Model No:
D-H1LF-P and D-H1NF-P and CN-01, CN-04
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive and Standard.
Place:
Date:
Reno, Nevada USA
December 9, 2021
(Signature)
Michael Silveri, President
GETTING TECHNICAL ASSISTANCE
To get assistance for product installation or commissioning, contact Halogen technical support at