background image

Professional Dual Rise 
Roman Blind System

adjust your spools...

Step 1. 

Ensure the cords are fully unwound.

Step 2. 

Remove the cord from the cord guide.

Step 3. 

Pull the grey button..

Step 4. 

Re-position your spool and push each grey button  

down to lock them into place.

Step 5. 

Re-attach the cord to the cord guide, at the opposite 

end of the spool.

1.

2.

3.

4.

1.

2.

3.

5.

4.

6.

change the control side of your 
Dual Rise Roman Blind…

Step 1. 

Using a T10 torx allen key undo both screws on the 

underside of the blind being careful not to fully undo.

Step 2. 

Pull out the Dual Rise gear mechanism from the head-

rail then turn the blind back over.

Step 3. 

Pull the mechanism completely out of the headrail and 

undo the screw which secures the axle rod to the gear housing.

Step 4. 

Re-fit the axle rod at the opposite end of the blind 

making sure its securely held in place, then push the Dual Rise 
mechanism back inside the headrail about ¾ of the way in.

Step 5. 

Turn the headrail over and lift the flap up and push the 

gear housing all the way in securely, then tighten both screws 
with a T10 torx allen key.

Step 6. 

Re-adjust the position of your spools accordingly making 

sure both the grey buttons are ushed down firmly and the cord 
is properly fed through the cord guide.

IMPORTANT: 

please check all grey buttons have been pushed down and the cord is attached to the cord guide before operating your blind.

1.

2.

3.

5.

4.

6.

fit a longer chain or wand to 
your Dual Rise Roman Blind…

Step 1. 

Pull back the white cover and remove the chain from 

the clear clip.

Step 2. 

Slide the cord pull up the chain to reveal the connector.

Step 3. 

Unclip the cord connector from the chain.

Step 4. 

Using a small pick or similar pull back the white cap 

from one of the Dual Rise cords to reveal the ball chain 
connector.

Step 5. 

Attach your new chain or wand to the ball chain 

connector.

Step 6. 

(Skip this step if you have fitted a wand) Take your 

chosen cord pull and pass your chain through the small 
opening then fit the 0908R connector to the bottom of the 
chain. Repeat steps 4,5 & 6 for the other Dual Rise cord.

Reviews: