HALE AP, Technical Manual

Page: 14 / 177

2
1.3. Training
AP, CBP, MBP, and RSD pumps must only be operated and maintained by trained personnel.
Training is available via the Hale Products Inc. website (www.haleproducts.com ), Godiva √erified
Training (godiva.co.uk), or through your local dealer or vehicle manufacturer. The Hale website
provides a description of the course content and general information about the training, includ-
ing an invitation to register with the EVT Certification Commission (www.evtcc.org) to take one
EVT exam at the Hale facility.
NOTE
Be sure to record the contact phone number and contact person’s information before
completing the form.
Complete the SESSIONS, ORGANIZATION CONTACT INFORMATION, STUDENT CONTACT INFOR-
MATION portions of the form. Check the Captcha (provides the proof of human input) and then
click the SUBMIT button at the bottom of the page.
NOTE
Under the FAST buttons select No unless your facility is a FAST center. Do NOT click
Yes unless you know for sure you are a FAST member requiring certification or recer-
tification (a certification is valid for 4 years).
When the Thank you for Registering page appears record the halemarketing email address (Add
this address to your email address book to prevent your response from being routed to the Junk
folder.) and call the contact phone number (recorded earlier) to arrange payment.
NOTE
Due to demand, classes fill far in advance of the scheduled dates. The ONLY way to
hold the selected dates is to pay at the time of enrollment submission.
1.4. Safety Summary
DO’S
•
When installing or removing the pump, use ONLY appropriately rated lifting equipment that
has been inspected and is in good condition.
•
Use/wear all required PPE when operating the pump (including for maintenance purposes).
See paragraph 1.1, PPE.
DON’TS
• Do NOT remove guards; rotating parts must be guarded against accidental contact.
•
Do NOT insert items into the suction tube when pump is running.
•
Do NOT disconnect discharge hoses while the unit is running.
•
Do NOT loosen/unfasten/remove components while the unit is running.
The following warnings and cautions are used throughout this manual and are provided here as
a safety summary. WARNINGS or CAUTIONS within a procedure (preceding an individual step),
apply directly to that step, however WARNINGS or CAUTIONS that precede the entire procedure,
apply to the ENTIRE procedure.
A PRESS PRESENTS A POTENTIAL CRUSH HAZARD (FROM MOVING PARTS) AND/OR
STRIKE HAZARD (FROM EJECTED PARTS). WEAR APPROPRIATE PPE.