2 Safety
2.1 Intended use
14
2.1.1
Structural changes to the Positioning clamping pin
Design and manufacturer's acceptance are based on the Product Safety Act (ProdSG).
No changes, additions or conversions may be made to the Positioning clamping pin
without the prior written consent of Erwin Halder KG.
In case of non-compliance, the Positioning clamping pin lose their EC conformity. With
this, the manufacturer of the Positioning clamping pin is outside of the warranty.
Immediately replace components that are not in problem-free condition.
Only use original spare parts / wear parts / accessories. These parts are specially
designed for the Positioning clamping pin. For parts purchased from third parties it cannot
be guaranteed that they have been designed and manufactured to meet the requirements
on stress and safety.
Parts and optional equipment not supplied by Erwin Halder KG are not approved for use
on the Positioning clamping pin.
2.1.2
Foreseeable misuse
Any use of the Positioning clamping pin beyond the intended use, and/or other use, can
lead to serious injuries.
–
Use the Positioning clamping pin only as intended.
–
Do not use the Positioning clamping pin if maintenance or inspection are lacking.
–
Never use thePositioning clamping pin without the locking via hexagon socket.
–
Do not use the Positioning clamping pin with constantly rotating loads.
–
Do not use the Positioning clamping pin to lift, hold or carry people.
