Cleaning technology
•
Municipal technology
Servicing instructions for Citymaster 650
88-10-3209-4001-
Emptying the dirt hopper
Park the vehicle in a suitable place for cleaning. Unlock the fasteners of the dirt hopper. Start the vehicle with the
ignition key (A). Raise and empty the dirt hopper with the tip switch (B). Close the cover again after emptying the
dirt hopper.
Cleaning the sweeping unit and the suction mouth
Switch sweeping mode on with the tip switch (C). Lower the sweeping unit with the joystick (D) and switch the
suction fan on in the multifunction display with the turn-push knob (E). Clean the sweeping unit and the suction
mouth from the outside with water. Raise the suction mouth with the joystick (D) and open and lock the coarse
dirt flap with the pedal (F). Clean the suction mouth from the inside with water.
Cleaning the suction fan
Connect the water hose to the suction fan and clean for about two minutes in sweeping mode. Remove the water
hose and let the suction fan run for about two more minutes. Switch sweeping mode off with the tip switch (C).
Lower the sweeping unit with the joystick (D). Close the coarse dirt flap with the pedal (F).
Safety information
These servicing instructions may be used only in conjunction with the original operating manual!
All cross-references refer to the pages in the Citymaster 650 operating manual.
•
Please observe the safety information in the operating manual, as from page 11!
•
Information about special risks, as from page 16!
•
The vehicle may be put into operation only by trained personnel!
C
B
A
E
F
D
F
C
D
