Hakko Electronics V Series, Connection Manual

Page: 269 / 332

App5-44
Appendix 5 Ethernet
Errors during Macro Command Execution
The execution result of macro commands SEND/EREAD/EWRITE is stored in system memory
address $s515.
•
System memory address: $s515 (response to the request)
Code Contents Solution
0 Normal
200 to 2000 Communication error Refer to “Communication Errors.”
−
30 Timeout Check if an error is occurring to the target V7.
−
31
The number of words being sent
exceeds the limit. Check the number of words that can be sent in
macro editing.
−
32 Specified table not used Check the setting on the network table.
−
33 Cannot use the send command. Check the macro command in macro editing.
−
34 Specified table being used
Check that system memory address $s514 is set. If
not, reduce the frequency of communications.
−
35 Cannot process due to short memory Check the memory space at the target station.
−
36 Illegal receive packet bytes Check the requested number of words.
−
37 Memory access error Check the setting of the requested memory.
−
38 Macro setting error Check the macro setting.