Hakko Electronics Monitouch V Series, Reference Manual

Page: 437 / 746

Chapter 15 Print
15-6
Sato’s Barcode Printer MR400
This setting is required when connecting Sato’s barcode printer MR400 and
printing barcodes.
Memory Card
To use this function, a memory card is required for MR400. For the memory
card type and mounting procedure, refer to the instruction manual for the MR400
series.
Card Slot Number Setting and Memory Card Formatting
To enable the use of memory cards, set the memory card slot number and
format the memory card on MR400.
1. Turn off the power to MR400, and insert a memory card into the card slot on
the backside of MR400.
2. Hold down the LINE key on the front of MR400, and turn the power on.
“USER MODE” is displayed on the front panel.
3. Press the LINE key and FEED key at the same time. “ADVANCED MODE”
is displayed.
4. Press the LINE key and FEED key at the same time again. “CARD MODE”
is displayed.
5. Press the FEED key until “CARD DRIVE NO/ 1 2” is displayed. Set the
memory card slot number. Press the LINE key to select, and press the
FEED key to determine.) This drive number is the memory card slot number.
6. Press the FEED key to determine the options. Select “YES” for “CARD
FORMAT/ YES NO” and format the memory card. If no error is given,
formatting is successfully done.
7. To quit “CARD MODE,” turn the printer off.
•
When screen data is transferred after editing the MR400 format table
(register), formatting is required. In addition to the above formatting
procedure, it is possible to format the memory card by outputting the control
command of MR400 from the V series. ( Refer to Example 1 (page
15-14).)
Read the instruction manual and command reference book for Sato’s barcode
printer MR400 series before using this function.
Memory card formatting is the same as floppy disk initialization.