Hakko Electronics Monitouch V Series, Reference Manual, Page: 423 / 746

Chapter 13 Macro
13-40
♦
Graphic Movement on the Screen
When the switch is pressed, a graphic from the graphic library is displayed. At
the same time the graphic displayed at the left corner of the screen starts to
move to the right. Pressing the switch clears the graphic. When the graphic is
displayed again, it appears in the same position as displayed last, and starts to
move to the right.
Screen Edit
• Graphic relay mode • Interval timer mode
[Division No.: 0] [Division No.: 1]
[Memory: $u100-00] [Macro Block No.: 1]
Type: 1-Graphic] Time-up Time: 0]
[Start Graphic GNo & No: 0 & 0]
[ Start Mem. Designation: $u100-00]
[Number of Relays: 1]
[ Stop Timer after Execution of Macro]
[Parameter: 1]
[ ON Macro Block No.]
[Process Cycle: Low Speed]
[ OFF Macro Block No.]
[Process Cycle: Low Speed]
• Switch
[Output Memory: $u100-00] [Output Action: Alternate]
[Lamp Memory: $u100-00]
$u100-00 = ON
Output memory for switch
OFF
$u100-00 = ON
Graphic relay
Macro block No. 1 = Executed at every cycle
Macro
The graphic is displayed on the screen.
Change the X parameter of the graphic.
Pressing the switch sets or resets $u100-00.
(Interval timer)
When $u100-00 is set (ON), graphic No. 0 in group No. 0 is displayed and macro
block No. 1 is executed at every cycle.
(Graphic relay)
Since [Parameter] is set in the graphic relay mode, $u101 becomes the memory for
the parameter.