Hakko Electronics Monitouch V Series, Reference Manual, Page: 422 / 746

Chapter 13 Macro
13-39
13
Interv
al
Tim
e
r
Interval Timer Examples
♦
(1) Screen Change Switch that must be Held Down for Five Seconds
Screen Edit (Example: Screen No. 0)
Macro Block Edit (Example: Macro Block No. 0)
Line No. 0 $u00100 = 1
Line No. 1 SYS (SET_SCRN) $u00100
With the above setting, the screen display is not changed even if the switch on
screen No. 0 is pressed. It changes to screen No. 1 only when the switch is held
down for five seconds.
Screen No. 1
Screen No. 1
Execution of macro block No. 0 = Screen No. 1 call
Time-up Time = 5 seconds.
M100 = ON
Time
Macro
Output memory for switch
OFF
Hold down for five seconds.
• Switch • Interval timer mode
[Output memory: M100] [Division No.: 0]
[Output Action: Momentary] [Macro Block No.: 0]
[Time-up Time: 50] (= 5 seconds)
[ Start Mem. Designation: M100]
[ Stop Timer after Execution of Macro]
[ ON Macro Block No.]
[ OFF Macro Block No.]
[Process Cycle: Low Speed]
Pressing the switch sets M100 (ON). In five seconds, macro block No. 0 is executed.
The above command is a system call command to bring up screen No. 1.