Hakko Electronics Monitouch V Series, Reference Manual, Page: 180 / 746

Chapter 6 Message Display (Relay/Message)
6-17
6
Rel
a
y
Mod
e
♦
Display Area Part for Relay-sub Mode
Messages and graphics registered for displays in relay-sub mode must be
displayed in dedicated display area parts.
For more information on the procedure of creating this display area part, refer to
page 6-9.
♦
Roll Up/Roll Down Switch for Relay-sub Mode
This is an auxiliary switch only active when [Block: Page Block/Direct Block] is
set in the [Relay-sub] dialog. It works as a roll-up/roll-down switch only used
when the sub-display messages exceed the bounds of the display area.
[Division No.]
Set the same division number as the one specified in the [Relay] dialog of
the link location so that you can determine which roll-up/roll-down switch is
linked to which mode.
[Function]
This option determines the function of the switch. Select [Function: Roll
Up/Roll Down]. If the switch is one that was selected from the relay-sub
mode tool bar, the default for [Function] will be [Roll Up] or [Roll Down].