Hakko Electronics Monitouch V Series, Reference Manual

Page: 169 / 746

Chapter 6 Message Display (Relay/Message)
6-6
[Execution Relays] (1 to 512)
Specify the number of relays (total number of bits for messages) to be used
in this mode. The maximum available number is 512.
[Action Area]
Choose from [Area], [Switch] or [Lamp] for specifying the place where the
message should be displayed on the screen.
Area: Shows messages on display area parts placed on screen.
Switch: Shows messages on switch parts placed on screen. Switches
are set in [Function: Mode]. Each switch has [Display Order]
as an auxiliary item where you can specify which relay
message to display on which switch.
When you do not set [Display Order], the messages are
displayed in the same order that the switches were placed.
Lamp: Shows messages on lamp parts placed on screen. Lamps are
set in [Function: Mode]. As with switches, each lamp is set
with the auxiliary item [Display Order].
[Lines per Relay] (1 to 24)
This option is valid when [Area] is chosen for [Action Area]. Specify the
number of lines to be linked with one relay (= one bit).
Priority in displaying messages
Priority is given in displaying messages in relay mode. This is based on message
numbers that are registered in message editing. The smaller numbers have a higher
priority. This is the case for group numbers as well as message numbers. When
messages are displayed on the screen, those of higher priority are displayed above.
Example:
A tank error
B tank error
C tank error
A line stop
B line stop
C line stop
M10
M11
M12
M22
M23
M24
Priority High
Small
Occurrence order display
There is another way to display some messages in the order of occurrences instead of
priority. This is called “relay- sampling.”
For more information, refer to “Chapter
10 Sampling.”