Hakko Electronics Monitouch V Series, Reference Manual, Page: 117 / 746

Chapter 3 Switch
3-22
To Print out the Screen Display (= Hard Copy):
Use the [Function: Hard Copy] switch. Create the [Function: Hard Copy] switch
on the screen. When you press that switch, the displayed screen is printed.
During printing, other operations on the screen will function.
[Occupy]
1. Only when [Multi-link] is chosen for [Connection] by selecting [System
Setting]
→
[Comm. Parameter]
→
[Detail] tab. [Occupy] can be chosen.
2. In the case of multi-link, multiple MONITOUCHs are connected to one PLC
(n : 1). Selecting [Occupy] limits communication between one MONITOUCH
and the PLC (1 : 1). Other MONITOUCHs are stopped. On the top left
corner of these MONITOUCHs, “Occupied by other station” is displayed.
3. Pressing the [Occupy] switch lights up the lamp in the switch. (This lamp
lights up even when [Lamp Memory] is set.) Pressing the [Occupy] switch
again resets the condition, and the lamp in the switch goes off.
Communications are started between one PLC and multiple MONITOUCHs
again.
Animation
Change
Screen
Z Z Z
Labeller
Z
Unloader
Hard
copy
OK
Animation
Change
Screen
Z Z Z
Labeller
Z
Unloader
Hard
copy
OK
Hard
copy
Press the switch.
When the screen is printed with the [Function: Hard Copy] switch, that switch is also
printed out. There is a way to print with an external command if you do not want to print
out the switch. (
Refer to “Chapter 1 System Setting.”)
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
Occupied by another station