2015.10
MA02756XZ151015
連接部
隔離器
電路板
插座
電磁蓋
真空泵組件
螺釘
×
×
×
×
×
×
×
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
●
Thank you for purchasing the HAKKO FR-410 Desoldering Tool.
Please read this manual before operating the HAKKO FR-410.
Keep this manual readily accessible for reference.
●
Table of Contents
...................... 1
................................................. 1
................. 2
...................................................... 3
.......................................................... 4
........................................ 7
..................................................... 8
...........................11
1.
PACKING LIST AND PART NAMES
2. SPECIFICATIONS
3. WARNINGS, CAUTIONS AND NOTES
4. INITIAL SETUP
5. OPERATION
6. PARAMETER SETTING
7. MAINTENANCE
8. TROUBLE SHOOTING GUIDE
© 2015 HAKKO Corporation. All Rights Reserved.
OVERSEAS AFFILIATES
U.S.A.: AMERICAN HAKKO PRODUCTS, INC.
TEL: (661) 294-0090 FAX: (661) 294-0096
Toll Free (800)88-HAKKO
4 2 5 5 6
http://www.hakkousa.com
HONG KONG: HAKKO DEVELOPMENT CO., LTD.
TEL: 2811-5588 FAX: 2590-0217
http://www.hakko.com.hk
E-mail:[email protected]
SINGAPORE: HAKKO PRODUCTS PTE LTD.
TEL: 6748-2277 FAX: 6744-0033
http://www.hakko.com.sg
E-mail:[email protected]
Please access to the following address for the other Sales affiliates.
http://www.hakko.com
HEAD OFFICE
4-5, Shiokusa 2-chome, Naniwa-ku, Osaka 556-0024 JAPAN
TEL:+81-6-6561-3225 FAX:+81-6-6561-8466
http://www.hakko.com E-mail:[email protected]
8. TROUBLE SHOOTING GUIDE
NOTE :
When repairs are needed, please send
both the handpiece and the station to
your sales agent.
WARNING
Before checking the inside of the HAKKO FR-410 or replacing parts, be sure to disconnect the power
plug. Failure to do so may result in electric shock.
●
Display does not turn
on.
●
Pump does not
operate.
●
Solder is not being
absorbed.
●
The nozzle does not
heat up.
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
CHECK
:
ACTION :
Is the power supply cable or connection plug disconnected?
Connect it tightly.
Is the fuse blown?
Replace the fuse. If the fuse blows again,
please send the entire product back to us for repair.
Is the power supply cable or connection plug disconnected?
Connect it tightly.
Is the heater tube or nozzle clogged?
Clean it.
Is the filter pipe full of solder?
Clean it.
Is the ceramic paper filter hardened?
Replace it with a new one.
Is there a vacuum leak?
Check the connections and filter pipe seals and
replace any worn parts.
Is the heater tube or nozzle clogged?
Clean it.
Is the desoldering gun cord assembly properly connected?
Connect it tightly.
Is the heating element damaged?
Replace it with a new one.
Desoldering Tool
(HAKKO FR-4101)
Instruction Manual