27
HakkiPilke 50 Easy
Version 1.2 2012
5.5.
Changing the oil of the angle transmission
When replacing the angle transmission, do the
following:
1.
Remove the V-belts according to steps 1–5
of Section 5.2.
2.
Disconnect the angle transmission from the
pump on its left side (4 x 8 mm hex socket
bolts).
3.
Lower the motor bed to the lowest possible
position in order to have sufficient room to
open the fastening bolts on the bottom of
the angle transmission (4 x M12 bolts).
4.
Turn the angle transmission so that it can
be removed, and pull it out.
Note! The angle transmission weighs approx.
20 kg.
Figure 23. Replacing the angle transmission
5.
Open the angle transmission's drain
opening D (hex socket 8 mm), and drain the
oil from the angle transmission (1,2 l) into a
suitable container. Close the drain opening.
6.
Open the filler opening B and the oil check
opening C, and add oil through the filler
opening until the oil level reaches the oil
check opening C. Close both openings.
7.
Remove the angle transmission's breather
A, and ensure that it functions properly by
moving the spring plate inside it with a
screwdriver, for example.
8.
Re-attach the breather to the angle
transmission, and make sure that the angle
transmission does not leak oil
9.
Re-install the angle transmission.
10.
Install and tighten the V-belts according to
steps 6 and 7 of Section 5.2.
Figure 24. Changing the oil of the angle transmission
