Haivision Makito, User Manual

Page: 123 / 294

Managing Users and Security
Viewing System Status Information
Makito User’s Guide, v2.1.0, Issue 01 123
4.
To display a snapshot of system information, see “Taking a System Snapshot” on
page 124.
Status Settings
The following table lists the Status settings and controls. Status information can be useful
for troubleshooting and may be forwarded to Haivision Technical Support if you are
requesting technical support.
Status Setting Description/Values
OK (or error message if applicable).
The type of encoder, e.g., Makito-DVI Encoder.
The Haivision part number for the encoder, e.g.,
B-290E-DVI or B-290E-HDSDI
The serial number for this encoder appliance or card.
The firmware version of the encoder, e.g., v2.1.0-33
The firmware release date.
(If applicable) Firmware options installed at the factory,
e.g., SW-290E-KLV-COT (Metadata Capture KLV &
COT). For more information, see “Configuring Metadata
Capture” on page 80.
The hardware version of the encoder.
A1 (basic card assembly).
The CPLD firmware version of the encoder.
The Boot version of the encoder.
The length of time (mm:ss) the encoder has been “up”
and running.
The combined video encoding processor usage in
percentage% (combining both Hi and Lo streams).
Reboots the encoder. See the following section,
“Rebooting the Encoder” .
Displays a snapshot of system information in a new
window. See “Taking a System Snapshot” on page 124.
Resets the video encoder. Performs the equivalent of the
CLI command videnc 0 reset .
Card Status
Card Type
Part Number
Serial Number
Firmware Version
Firmware Date
Firmware Options
Hardware Version
Hardware Compatibility
CPLD Version
Boot Version
System Uptime
Encoding Chipset Load
Reboot
System Snapshot
Reset
NOTE:
This is
not
equivalent to a Hardware Reset (see
“Resetting the Encoder” on page 54).