www.haivision.com
Makito X4 Encoder 1.1
Makito X4 Rugged Encoder Installation Guide
21
Generated on: 2024-02-08 22:26:05
HVS-ID-IG-MX4ER-11, Issue 01
1.
2.
3.
4.
5.
Then set up VLC to decode the stream (as shown in the following procedure). This will validate your
setup.
Connect the PC with VLC on the same network as the Makito X Series Encoder. Note the IP address
of the PC.
On the Serial connector or through an SSH connection, create a stream from the Makito X encoder
to the PC.
For example:
stream create addr={IP of the pc with VLC} port=2000 videosrc=0
Once the stream is created, you can validate that the encoder has started encoding by executing
either of the following commands:
"stream all get table"
or
"videnc all get table"
On the PC, open VLC and under the "Media" tab, select
"Open Network Stream...".
Under
"Please enter a network URL:"
, enter
"udp://@:2000"
and click
Play
.
The stream should start within seconds. In case of failure, replace the "@" by the actual IP address
of the PC.