www.haivision.com
Makito X1 Rugged Encoder 1.0
Makito X1 Rugged Encoder Installation Guide
11
Generated on: 2024-02-08 21:18:37
HVS-ID-IG-MX1E-10, Issue 02
1.
Powering up the Makito X1 Encoder
MX1 Rugged v2 (#S-MX1E-R-V2-SDI1)
MX1 Rugged (#S-MX1E-R-SDI1)
There is no power switch on the encoder. The power is automatically on when the unit is plugged in.
To power up the encoder:
Connecting to the Network and Audio/Video Sources
) Insert the
Power/Audio/
Serial
breakout cable connector
into the encoder's
the encoder's
power input port (
DC In & I/O
).
Both AC and DC power cables
(shown following)
are shipped as part of the Evaluation Kit (#S-
MX1E-R-SDI1-DK).
Warning
When using the AC/DC power adapter, the power cord is the main disconnect device. Ensure that
the socket-outlet is located/installed near the equipment and is easily accessible.
ATTENTION
Quand on utilise l'adaptateur AC à DC, le cordon d'alimentation est utilisé comme
interrupteur général. La prise de courant doit être située ou installée à proximité de l'équipement et
être facile d'accès.