www.haivision.com
Makito X1 Rugged Encoder 1.0
Makito X1 Rugged Encoder Installation Guide
8
Generated on: 2024-02-08 21:18:37
HVS-ID-IG-MX1E-10, Issue 02
•
•
•
•
•
•
1.
2.
Connecting to the Network and Audio/Video Sources
MX1 Rugged v2 (#S-MX1E-R-V2-SDI1)
MX1 Rugged (#S-MX1E-R-SDI1)
The Makito X1 Rugged enclosure provides the following rugged connectors:
Power & I/O
connector combining these inputs:
Power
(+5VDC, < 6 W)
Analog Audio
(Future use)
Two (2) channels of analog audio – 33 Kohms input impedance)
Serial
Port
(
RS-232/422 – can be used for Management, Pass-thru or KLV or CoT metadata
ingest)
CVBS/SDI
connector
–
75 Ω
BNC
(used for
either SD-SDI (Serial Digital Interface), HD-SDI video, or
Composite (CVBS) input signals, with format auto-detected)
Network
connector – 10/100/1000 Base-T Gigabit Ethernet; connector also includes a Reset line
The BNC connector is also a 3G-SDI capable interface supporting 1080p 50/60 fps video @ 3Gbps. In
addition, it supports auto-detection of the HD resolution and embedded digital audio.
The Ethernet/Factory Reset and Power/Audio/Serial breakout cables (shown in the following steps) are
shipped as part of the Evaluation Kit (#S-MX1E-R-SDI1-DK).
To connect the encoder to the network and A/V sources:
Remove the protective caps from the encoder's connectors.
Connect the encoder's
Network
port to the IP network using the
Ethernet/Factory Reset
breakout
cable (shown following):