Haivision Makito X, User Manual, Page: 33 / 404

Introduction
Physical Description
Makito X User’s Guide, v2.0, Issue 01 33
LED Status Indicators (Rear Panel)
The LED colors and flashing (blinking) speed indicate the status (operational state) of the
Makito X encoder.
Figure 1-20 LED Status Indicators
Table 1-1 LED Status Indicators
Function Description Indication
STATUS OFF No power
RED Solid Error / Fault
GREEN Blinking Booting / Initialization
GREEN Solid No Fault / OK
TX1 / TX2 [SDI] OFF No video encoder is configured to use a
given BNC.
NOTE:
Each TX LED is associated with the
corresponding BNC connector.
AMBER Solid Either of the conditions below is sufficient to
turn the LED AMBER:
• Encoder booting
• Valid video input NOT detected (i.e., if
you configure an encoder to use a BNC
and there is no video input lock).
GREEN Solid Valid video input detected (i.e., you have
signal lock).
DVI-A / DVI-D OFF No valid signal is recognized; both LEDs are
Off.
GREEN Solid DVI-D: a valid digital signal is plugged in.
-OR-
DVI-A: a valid analog/component signal is
plugged in.