Haivision Makito X, User Manual, Page: 117 / 404

Managing the Encoder
Configuring Metadata Capture
Makito X User’s Guide, v2.0, Issue 01 117
Baud Rate
115200 Select the bitrate for the COM Port to match
the protocol for connected RS-232/422
equipment. Choose from:
1200, 2400,
4800, 9600, 19200, 38400, 57600
or
115200
.
Data Bits
8 Select the databits for the COM Port:
8
Parity
None Select the parity for the COM Port:
None
Stop Bits
1 Select the stopbits for the COM Port:
1
Flow Control
None Select the flow control for the COM Port:
None
Network Settings (UDP l Input only)
IP Address
n/a (Optional) The address is only required for
reception of multicast metadata. In this case,
you need to provide the multicast IP address
to which the data is being sent.
You can also specify the address if you only
want to accept KLV messages coming from
a specific sender.
Port
n/a (Required) Specifies the local UDP port on
the Makito X that is receiving the packets.
n/a These buttons become available to control a
metadata stream once it has started
streaming (after you click
Apply
).
Click Stop to stop an active stream.
Click
Start
to restart a stopped stream.
n/a Click Statistics to view statistics for the
stream. See “Streaming Statistics” on
page 139.
CoT Relaying (
See “Configuring CoT Retransmission”
on page 112)
CoT Relaying off
When set to On, the system will retransmit
received CoT/UDP or CoT/Serial metadata
to up to 8 other hosts over UDP.
on,off
+Relay
n/a
Use to specify the IP address and UDP port
for each relayed packets. You can optionally
specify the
ttl
and
tos
.
TTL 64
Time to Live. See TTL on page 137.
ToS 0xB8
Type of Service. See ToS on page 137.
Metadata Setting Default Description/Values (Cont.)