Kraken CR Installation Guide
Powering Up Kraken CR
HVS-ID-IG-KRAK-CR-26, Issue 01
Page 3 of 14
NOTE
To capture metadata from the serial port, set the terminal parameters as follows to communicate
with Kraken:
•
Baud Rate: 115,200 bps
•
Parity: None
•
Flow Control: None
•
Data Bits: 8
•
Stop Bits: 1
3.
To connect to the Kraken CR console UI, connect the Mini
DisplayPort
to a monitor. Use an HDMI or DVI
adapter, if required.
4.
To capture HD/SD-SDI digital video, connect your video source cable to the
SDI
input (BNC connector, shown
following).
Kraken CR - Back
5.
To capture Analog Composite video, connect your video source cable to the
COMP
input (BNC connector).
Powering Up Kraken CR
1.
Plug the DC connector into the power connector at the rear of the unit (shown in the above figure).
2.
Plug the power cord into the AC adapter and plug the cord into a grounded AC power source.
NOTE
There is no power switch on the Kraken CR. The power is automatically on when the unit is plugged
in. The power supply cord is used as the main disconnect device.
Ensure that the AC socket outlet is located near the equipment and is easily accessible.
SDI Input
Analog Composite Input
Power Connector
Analog Audio Input (future)