Installing the Encoder
Hardware Maintenance
Makito
X User’s Guide, v2.2, Issue 02
60
Hardware Maintenance
The following maintenance tasks are recommended for the Makito
X
appliance.
Cleaning the Ventilation (Intake/Outtake) and Filter
To clean the intake and outtake vents, use a dry cloth or an aspiration device approved for
electronic equipment.
Maintenance should be done every 6 months (more often in a dusty environment).
Monitoring of the Fan Operation
There is no system level monitoring of the fan operation; however, it is recommended that
you check to see if the fan is operating in one of two ways:
•
If the appliance is easily accessible, turn the unit over and listen (an operational fan
makes a humming noise).
•
Use the CLI (
temperature get
command) to get information from the built-in
temperature sensors (see
364). If the internal temperature of the
unit is rising, that is an indication that the fan may not be operating properly.
Replacing the RTC Battery
The Makito
X appliance contains a real-time clock (RTC) powered by the following
battery:
•
Varta CR2032 with 2-wire connector Mfr. Part#: 06032101030
At the end of its life (7-10 years), the battery should be replaced by the end user with the
same battery or an equivalent model approved by Haivision.
The Makito
XR has no battery.
TIP
The RTC battery needs to be replaced if at a power-cycle event, the system time and
date are reset to within 24 hours, depending on your time zone, of January 1, 1970
(Coordinated Universal Time, UTC).
NOTE
The used battery should be disposed of and recycled in accordance with your
national/local battery collection schemes.
