Managing the Encoder
Configuring Metadata Capture
Makito
X User’s Guide, v2.2, Issue 02
120
SPI UID
n/a
(
CoT
input only) Double-click the text box to
display the list of the SPI messages detected
by the Makito
Xand select a string for the UID
filter.
Serial Settings (Makito
X with SDI, Serial Input only)
COM Port
RS-232
Select the type of Serial interface:
●
RS-232 or
●
RS-422 (only available if the Metadata
Capture option is installed).
Baud Rate
115200
Select the bitrate for the COM Port to match
the protocol for connected RS-232/422
equipment. Choose from:
1200, 2400,
4800, 9600, 19200, 38400, 57600
or
115200
.
Data Bits
8
Select the databits for the COM Port:
8
Parity
None
Select the parity for the COM Port:
None
Stop Bits
1
Select the stopbits for the COM Port:
1
Flow Control
None
Select the flow control for the COM Port:
None
Network Settings (UDP l Input only)
IP Address
n/a
(Optional) The address is only required for
reception of multicast metadata. In this case,
you need to provide the multicast IP address
to which the data is being sent.
You can also specify the address if you only
want to accept KLV messages coming from
a specific sender.
Port
n/a
(Required) Specifies the local UDP port on
the Makito
X that is receiving the packets.
n/a
These buttons become available to control a
metadata stream once it has started
streaming (after you click
Apply
).
Click
Stop
to stop an active stream.
Click
Start
to restart a stopped stream.
n/a
Click
Statistics
to view statistics for the
stream. See
Metadata Setting
Default
Description/Values (Cont.)
