TOPlus mini / TOPlus premium pull-back
Installation
64
Order h49 7144.907-333
7.5.1 Compatibility check
Check the compatibility of the product and the connection
point of the machine.
For this, check that the connection point and the product
share the same adaptation geometry. Also check if the actu-
ating element / coupling element is suitable.
It may be necessary to install an adapter between the actu-
ating element on the machine and the product.
7.5.2 Preparation of the product
The product is supplied in assembled condition.
The following preparatory steps are needed to install the
product.
WARNING
Serious injuries caused by imbalance during in-
correct installation!
During preparation of the product for installation
on the machine, check that the balance marks on
the spindle flange and functional unit are still
there.
If the balance marks are no longer there, remove
the product from the machine and send it to HAIN-
BUCH.
INFORMATION
The drawtube adapter may already be installed in the
clamping device.
Depending on the geometry of the drawtube adapter,
it may be necessary to remove the drawtube adapter
to be able to dismantle the functional unit from the
spindle flange.
1. If necessary, unscrew and remove the drawtube adapter
from the product.
