MANDO Adapt T812
Faults
94
Order h49 7144.907-333
Fault
Possible cause
Remedial action
Remedied by
Check the workpiece material
Workpiece is
pushed away from
the stop position
Use an appropriate workpiece
end-stop
Indentations on
the clamping
surface
Clamping force is
too high
Reduce the clamping force to the
level applicable for the adaptation
clamping device and the work-
piece
Skilled special-
ist
Incorrect type of
clamping element
Use a suitable clamping element
Dirty clamping ele-
ment
Clean the clamping element
Damaged clamp-
ing element
Replace the clamping element
Dimensional differ-
ence between
workpiece diame-
ter and clamping
elements is too
great
Use clamping element with a suit-
able clamping diameter
Table 8:
Fault table
13.3 Commissioning after a fault has been remedied
After the fault has been remedied, perform the following
steps to recommission it:
1. Reset the emergency stop equipment.
2. Acknowledge the fault on the control unit of the machine
tool.
3. Ensure that no-one is in the danger area.
4. Start the machine tool.
