MANOK plus
Installation
Order h49 7144.907-333
63
7.7 Installation of the changing parts
A
Changing part variant direct screw connection
B
Changing part variant x-times axial screw connection
B1 Fixing screws changing part variant x-times axial screw connec-
tion
C
Changing part variant x-times axial screw connection bayonet
C1 Fixing screws changing part variant x-times axial screw connec-
tion bayonet
D
Changing part variant, central, axial screw connection
D1 Fixing screw changing part variant central axial screw connection
E
Changing part variant radially clamped
E1 Clamping screw changing part variant radially clamped
The changing parts, such as the workpiece end-stop, can be
installed in different ways.
If necessary, in addition to these operating instruc-
tions, you should also read and follow the operating
instructions for the relevant changing parts.
INFORMATION
To be able to install the changing part, it may first be
necessary to remove the clamping element.
1. As described in the »Preparation of the machine for in-
stallation« chapter, prepare for the following steps.
2. Move the clamping device into release position.
