Quick change-over system centroteX S
Maintenance
52
Order h49 7144.907-333
11.5 Lubricating the product
DANGER
Serious injuries caused by workpiece being
ejected centrifugally due to insufficient lubrication
of the product!
Maximum clamping force is reduced by approxi-
mately 20% if lubrication is insufficient.
Always comply with the maintenance intervals
[see »Maintenance schedule« chapter].
Lubrication takes place every time the system is cleaned,
maintained or assembled, and also when required.
1. Dismantle the product for lubrication purposes. Consult
the »Cleaning« chapter for details of the level of disas-
sembly required.
2. At all lubrication points, remove escaping, consumed or
surplus grease, and dispose of it in accordance with lo-
cally enforceable legislative provisions.
11.6 Use of lubricants
To achieve ultimate performance from the products, use the
specified lubricants.
Only use grease that complies with the fundamental require-
ments governing adhesion, pressure resistance and solubil-
ity in coolants. Furthermore, there must be no particles of dirt
in the grease because these cause an operational malfunc-
tion if they come between two interference fit surfaces. For
this, the following lubricants are recommended:
GP 355 universal grease
[see the HAINBUCH product catalogue]
Alternatively:
Lubricants
Manufacturer
Product designa-
tion
Grease
MicroGleit
GP 355
Klüber
QNB 50
Zeller & Gmelin
DIVINOL SD24440
Bremer & Leguill
RIVOLTA W.A.P.
Table 6:
Selection of lubricants
