Quick change-over system centroteX M
Installation
36
Order h49 7144.907-333
7.5 Installation of the product
A
Drawtube adapter
B
Spindle flange
B1 Fixing screws, spindle flange
B2 Transport thread spindle flange
C
Bayonet tension pipe adapter
D
Anti-twist device
D1 Fixings screw, anti-twist device
a
Test surface face run-out spindle flange
b
Test surface axial run-out spindle flange
1. As described in the »Preparation of the machine for in-
stallation« chapter, prepare for the following steps.
7.5.1 Compatibility check
Check the compatibility of the product and the connection
point of the machine.
For this, check that the connection point and the product
share the same adaptation geometry. Also check if the actu-
ating element / coupling element is suitable.
It may be necessary to install an adapter between the actu-
ating element on the machine and the product.
