– 17 –
Stacking Instructions
The GE Appliances 24-Inch Dryer is designed
to be placed on top (stacking) of certain 24-Inch
washers. Washer models that currently qualify
for stacking are:
• GFW148
NOTE
: If planning to stack the washer and dryer,
order Stacking Kit (
Part #
: GFA24KITL) to be
used on this dryer. The kit is sold separately.
WARNING!
• Make sure that the dryer is unplugged.
• Two people are recommended to safely lift the
dryer into and out of position.
• Avoid damage to the existing utility services.
Location Requirements
When installed in a location other than an alcove
or closet, the minimal clearances to combustible
surfaces and for air opening are:
• 1-inch on both sides
• 3-inches' front and rear
• 1-inch on top
Consideration must be given to provide adequate
clearance for installation and service.
NOTE
: If the dryer is approved for installation in
an alcove or a closet, it will be stated on a label
on the back.
When installed in an alcove or closet:
• The dryer MUST be vented to the outdoors.
• Minimum clearance between the dryer
cabinet and the adjacent walls or other
surfaces is 0 inches' either side, and 3 inches'
front and rear.
•
Minimum vertical space from floor to
overhead shelves, cabinets, ceilings, etc., is
67.7 inches.
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches
of open area equally distributed. If the closet
contains both a washer and a dryer, the
doors must contain a minimum of 120 square
inches of open area equally distributed.
KIT CONTENTS
(GE APPLIANCES KIT #: GFA24KITL)
• Remove the packaging.
• Flatten the product carton to use as a pad
to lay the dryer down on its side. Continue
using the carton to protect the finished floor in
front of the installation location.
Tools Needed
Installation Preparation
Bracket-
stack (R)
Bracket-
stack (L)
Screws (6) Short
For washer attachment
Screws (2) Long
For dryer
attachment
• Phillips-head Screw-driver
• Level
• Gloves
