Operation Method
For example, as shown in Fig.14, to set reservation 1 of water use to 10:30.
Under water storage type mode after the startup of this unit, continuously press the mode button to enter the
working mode of reservation 1, the reservation symbol and figure will be illuminated simultaneously, press setting
button to enter the hour setting status of reservation 1, the hour digit of reservation 1 will flash, and press
∧
or
∨
to adjust to 10:00. Press setting button to confirm the setting and enter into the minute setting status of reservation
1. Press
∧
or
∨
to adjust the value to 10:30. At this moment you can press setting button to confirm the current
setting, or this unit will conduct automatic confirmation and exit the setting about six seconds after non-operation.
The time setting process of reservation 2 is similar to that of reservation 1, namely use mode button to adjust the
working mode of this unit to the working mode of reservation 2, and use setting button to conduct the time setting
of reservation 2.
Note: If this unit is under reservation status, and a large amount of hot water is demanded after the heating of
water has started, it will result failure reach to setting temperature after the water heater reaches the reservation
time. The unit will automatically delay the heating for half an hour and it will stop after that. If the actual water
temperature has reached setting temperature before the reservation time, and meanwhile it hasn’t reached
reservation time after the actual water temperature is reduced, this unit will conduct the calculation of heating time
again, and determine if it needs to conduct heating again. In like manner, if the voltage of electric network is too
low, the heating power of water heater will not reach 2000W/1500W, and it will result failure to reach the set
temperature value after the water heater has reached reservation time, this unit will automatically delay the
heating for half an hour and it will stop after that.
10.
Standby
When bathing is finished, directly press the ON/OFF button to enter into standby status.
Warming Hints:
A.
Under a specific mode after the startup of this unit, press setting button to set ON/OFF time of each mode,
and adjust the time through
∧
or
∨
. If it is in prompt heating mode, you can press setting button to adjust
hour and minute of clock; and under reservation mode, you can press the setting button to set the reservation
time. The setting button is disabled under medium-temperature/heat preservation and intelligent modes.
B.
This unit has many safety protection devices, such as electricity leakage protection, over-temperature
protection, and short-circuit and open-circuit protection sensors, and it can realize full-circuit disconnection
and indicate fault codes. All fault protections are irrecoverable protection, and you must contact the after-sales
service department.
C.
This electric water heater has a power-failure memory function, there is no need to reset heating power,
heating temperature, clock, and working mode after a power failure, and it will directly enter the same
working status of water storage type before the power failure.
D.
In intelligent non-heating status, this unit is under standby status, and you can activate the interface through
any button on the control panel.
E.
In order to ensure the normal use of this unit, it is suggested that it should be kept away from any source of
disturbance (e.g. mobile phone). If there is any disturbance, this unit will enter anti-disturbance protection
status, and it will automatically resume one minute after the source of disturbance has been removed.
14
Water Storage Type
Setting
Heat
Preserv
ation
(Fig. 14)
Reservation
