The word "default" indicates the initial setting when the thermostat is
delivered from the factory.
00 Address
If you are using Communications Mode 0 or 1, and you are installing
more than one thermostat, each must be set to a consecutive address,
starting at 1. The default address setting is 1.
An address from 1- 127 may be selected.
01 Communications mode
The thermostat can communicate with remote systems in 2 modes.
These modes are:
0
300 baud, RS-232 mode (for use with personal computers)
1
100 baud, System mode (Omni, OmniPro, and Aegis systems)
The default setting is 1.
02 System options
The thermostat can be configured with the following system options:
0
Auto changeover
no fan with heat
1
Auto changeover
fan on with heat
4
Manual changeover
no fan with heat
5
Manual changeover
fan on with heat
12 Heat only
no fan with heat
13 Heat only
fan on with heat
20 Cool only
The default setting is 0.
11
