BLACK
WHITE
RED
YELLOW
LINE
NEUTRAL
LOAD
CONTROL
GREEN
GROUND
TOP
(ON)
BOTTOM
(OFF)
INDICATOR
LED
HAI UPB™ 15A Relay Switch and Auxiliary Switch
Installation and Operating Instructions
For the following Models:
40A00-1 HAI 15A Relay Switch (referred to as HAI UPB
™
Wall Switch, in this document), and
37A00-1 HAI Auxiliary Switch
READ THESE INSTRUCTIONS BEFORE INSTALLING DEVICE
This HAI UPB™ Wall Switch and Auxiliary Switch is intended for installation in accordance with the National Electrical Code and
local codes and regulations. It is recommended that a qualified electrician perform this installation. Retain these instructions for
reference.
This product is for indoor use only. Connect only copper or copper clad wire to this device.
Important Notes Prior To Installation
1.
All HAI UPB™ Wall Switches require a neutral (white) connection wire.
2.
Be sure that all power to the load has been disconnected by turning off the circuit breaker. Installing an HAI UPB™ Wall Switch
or Auxiliary Switch with power on may expose you to dangerous voltage and may damage the device.
HAI UPB™ Wall Switch Overview
The HAI UPB™ Wall Switch (Figure 1) allows for local control of loads by using the Decora-style rocker switch. It also incorporates
the UPB™ two-way powerline communication technology that gives it the ability to be remotely controlled by UPB™ compatible
controllers. The HAI UPB™ Wall Switch is also capable of transmitting UPB™ messages when the rocker switch is turned on or
turned off.
The HAI 15A Relay Switch is used to control loads such as receptacles, motor-operated appliances (i.e. fans), and fluorescent lighting
fixtures.
Figure 1 - HAI UPB™ Wall Switch
40I00-1, Rev B
