30
31
Assembly and Parts, Cont.
Injector Assembly
1
2
3
4
INSERT WITH RIB AT
9 O'CLOCK
POSITION
ITEM NO.
PartNo
DESCRIPTION
QTY.
1
93223
THROAT,INJECTOR,WHITE
1
2
53224
WHITE NOZZLE OVERMOLD
1
3
93806
O Ring
1
4
53235
Injector Cap
1
5
53005
Valve Insert
2
6
54112
1/2-inch Compression Assembly
1
7
90829
O Ring-223
1
8
95500
Dist Tube (23")
1
9
1
10
90819
O Ring-130
1
11
93201
1
12
93236
Distributor Screen
2
13
93239
Small Distributor Screen Material
2
Current Part #
Description
Quantity
1
100241946
Injector Throat
1
2
100237421
Injector Nozzle with Over-Mold Gasket
1
3
100242034
O-Ring
1
4
100037729
Injector Cap, Screw On
1
100238192
Entire Assembly (all of the above parts)
Figure 12: Injector Assembly
100241946
Injector Throat
In conjunction with the Injector Nozzle it creates the vacuum that draws the brine solution from the brine
cabinet. The center hole should be clear of debris, round, and undamaged. The Throat should be pressed
flush into the opening in the valve. If the Throat is removed, it must be replaced with a new one.
100237421
Injector Nozzle with
Over-Mold Gasket
Together with the Throat creates the vacuum that draws the brine solution from the Brine Cabinet. The
small hole in the Injector Nozzle is the one that creates the “injection stream” that enters the Throat. It
is important that this hole is round, undamaged, and clear of debris. If this hole becomes “clogged,” do
not use anything (such as metal objects) to clear this opening. Damage may occur. Use a clean cloth
and flush with water. If necessary, a wooden toothpick may be used. When assembling to the Valve, the
Nozzle hole should line up with the Throat. Flush screen with water to clean. The over-mold gasket seals
between the Injector Nozzle and the Injector Cap.
100037729
Injector Cap
Holds the injector assembly together and seals the assembly to the Main Control Valve.
Current Part #
Description
Quantity
1
100241807
Fill Plug
1
2
100241870
Fill Plug O-Ring Seal
1
100241857
Fill Plug Assembly (all of the above parts)
Figure 13: Fill Plug Assembly
100241807
Fill Plug
The Fill Plug seals the media access ports in the Media Tank. Care should be taken that the O Ring seal
area is kept clean and free of debris. Also, the O-Ring should be in the proper location in the groove. Do
not overtighten the Fill Plug when assembling. When the flange comes into contact with the Media Tank,
stop tightening. A 3/4-inch socket is recommended for assembly.
Assembly and Parts, Cont.
Fill Plug Assembly
