Models 7180 and 7380
Owner’s Manual
and Installation Guide
5/22/2019
18
Setting and Using the Controller—ST
The controller must be set up correctly for the appliance to perform properly.
Note:
Ensure that the bottom of the controller is firmly locked onto the four tabs on the top of the drive end cap assembly.
Regenerate Button
The Regenerate button is used when starting the water filtration appliance and to start an immediate regeneration. The
Regenerate button can be used in three ways:
1.
The Regenerate button can be used to put the appliance into an immediate regeneration.
A.
Press and hold the Regenerate button for about 5
seconds until the display changes to “Going to Backwash 1.”
B.
The appliance is in regeneration mode and will display the status of each cycle. After all regeneration cycles are
complete, the display will return to normal operating mode.
2.
The Regenerate button can be used to quickly advance through all of the
regeneration cycles to speed up the cycles, which is used when starting up or
diagnosing the appliance only.
A.
To advance through the regeneration cycles, tap the Regenerate button.
B.
The cycle position will display (for example, Backwash 1).
C.
Each cycle can be advanced by pressing the Regenerate button. Always
wait until the cycle position displays before advancing to the next cycle
position.
3.
Tap the Regenerate button in Normal operating mode to schedule a regeneration
tonight or toggle it off.
Figure 12: Regenerate Button
Customer Settings—ST
Service Settings must be set before Customer Settings; Service Settings should be set during installation of the
appliance.
To program Customer Settings on the controll
er, tap twice on the screen to bring up the “Main Menu.”
Tap “Customer Settings”
.
Note:
If a value displayed on the screen is correct, press Ok to move on to the next programmable value.
Step 1
Set Day and Time
Display reads “Set Time” followed by the current day and time that is set (Ex. Mon
01:00pm).
To Change the Day and Time
A.
Tap “day” to change the day of the week.
B.
Enter the time (hh:mm).
C.
Tap “AP” for AM or PM.
D.
When the desired day and time are displayed, press Ok.
