Hague Quality Water Maximizer 410, Owner'S Manual And Installation Manual

Page: 8 / 36

Model 410 Owner’s Manual 6/24/2014 8
Customer Settings
Service Settings must be set before Customer Settings; Service Settings should be set during installation of the
appliance.
To set Customer Settings, press and hold the
DISPLAY
(P) button for about five seconds while “Customer
Setting” displays. Release the button when “Set Time” displays. If the setting displayed is correct, press the
DISPLAY (P)
button to move to the next setting.
Step 1
Set Time of Day
Display reads “Set Time” followed by the current time that is set; the cursor will be under the
second hours digit.
To Change the Time of Day
A. Press the
CHANGE
(C) button repeatedly until the current hour is displayed. Ensure the time
is correct with regard to a.m. or p.m.
B. Press the
SELECT
(S) button to move the cursor to the right.
C. Press the
CHANGE
(C) button repeatedly until the current tens minute is displayed.
D. Do the same to set the minutes. Select a.m. or p.m. When the desired time is displayed,
press the
DISPLAY (P)
button to step to the next parameter.
Note: Whenever you experience an electrical outage, check your controller for the correct time.
Make any necessary corrections.
Step 2
Set Regeneration Time
Display reads “Reg. Time” followed by the current regeneration time that is set; the cursor will be
under the second hours digit. Usually you want to set a regeneration time when water will not be
used.
To Change the Regeneration Time
A. Follow the procedure outlined above for setting the time.
B. When the desired regeneration time is displayed, press the
DISPLAY
(P) button.
Step 3
Set Number of People—Mode 2 Only
Display reads “# People” followed by the current setting for the number of people in the
household; the cursor will be under the tens digit.
To Change the Number of People
A. Press the
CHANGE
(C) button repeatedly until the desired value is displayed; values will
cycle from 0 to 9.
B. Press the
SELECT
(S) button and the cursor moves to the right.
C. Press the
CHANGE
(C) button repeatedly until the desired value is displayed.
D. When the desired number of people is displayed, press the
DISPLAY
(P) button to exit the
Customer Setting mode.
When you press the
DISPLAY
(P) button at “# People,” the values are saved, and the controller
returns to Normal operating mode.
Programming Customer Settings Is Now Complete