12
Installation And Start-Up Procedures
8. Setting Number. For
Model 700MM
determine your controller setting number. Do not
guess at the setting; continued water quality problems or damage to the appliance could
result.
Follow the instructions on the pH and hardness test strips provided with your appliance to
determine the pH and hardness of your water.
Iron adjustment
: if pH is 7 or above and you know your water has iron, add 15 to
your hardness reading in grains per gallon and enter the result as your setting #.
Example: hardness in grains per gallon from test strip is 20 + 15 = 35 = setting #.
This is a temporary setting until you have an accurate water test.
If the result of your hardness test strip reaches the test maximum of 25 grains per
gallon, mix 1 cup tap water with 1 cup distilled water, then retest for hardness. Multiply your
reading x 2 and use this number as your setting number. If the test strip result is still 25
grains per gallon, call your HelpLine. Or, instead of using test strips, contact the company
below to test for hardness, iron and pH.
WATERSCREEN
National Testing Laboratories, Inc.
1-800-458-3330 - 9 am - 5 pm EST
If you feel you have an abnormal amount of iron, push the powerClean
®
button only.
Also, be sure to use salt with an iron-cleaning additive.
9. Adding Water & Salt. Be sure to remove any packaging or installation materials before
adding salt. Next, add no more than 2 gallons of water to the brine cabinet. Then add salt to
the brine cabinet, wait 2 hours then push the REGENERATE button and hold for 5 seconds.
A regeneration cycle will begin and continue as follows:
Model 700MM
33 minutes. After the
first regeneration, your softener will automatically refill the correct amount of water in the
brine cabinet. See figure 10.
10. Refill Salt when the salt level drops below the water level in the brine cabinet. Always
keep salt above water level. See figure 10
CAUTION!
Failure to install, operate and maintain your water treatment
appliance as instructed will VOID the product limited warranty.
NOTE!
Make sure the Owner's Limited warranty Card is filled in and mailed
within 30 days of installation. NO POSTAGE REQUIRED.
