7-52
SECTION 7 –
SPRAY SYSTEMS
3. Press the Manual (MAN) Rate Control
Switch (located on the side console).
4. Press the “
+
” Pump Speed/Rate Switch
(located on the side console) to increase
the solution pressure to desired PSI
(bar).
5. Press the Master Spray Switch (located
on the Hydrostatic Drive Control Handle)
in the OFF position.
6. Press the Solution Pump Switch (located
on the side console) in the DOWN (Off)
position.
7. When rinsing is complete, press the
Rinse Switch to the OFF (mid) position.
FOAM MARKER SYSTEM
- If Equipped
The Foam Marker system increases
efficiency in the field when spraying by
utilizing water from the rinse tank and mixing
with the foam concentrate from the foam
reservoir.
Rinse Mode Indicator
(Located on the Machine Display
Home Page - Field Mode)
Manual “MAN” Rate Control Switch
(Located on the side console)
-Typical View
CAUTION
Maximum foam regulator pressure is
20 PSI (1.4 bar). Use of higher pressure
may cause personal injury and system
damage and will void the warranty.
“+” Pump Speed/Rate Switch
(Located on the side console)
-Typical View