4-1
5
- D
A
SH
/ A
UT
O
SECTION 4 – ENGINE AND DRIVE SYSTEMS
ENGINE - STARTING
NOTE: An Insufficient Cab Air Pressure
Indicator will appear on the Machine
Display Home Page - Road or Field
Mode each time the machine is started,
due to a slight activation delay of the
RESPA
®
Cab Filtration System. The
indicator will disappear once the cab
becomes pressurized.
Pre-Operational Checklist
1. Check engine oil level.
NOTE: Do not operate the machine when oil
level is below the “L” (low) mark or above
the “H” (high) mark on the engine oil
dipstick.
2. Check coolant level.
3. Check diesel exhaust fluid level (Tier 4 Final
engines only).
4. Check hydraulic reservoir oil level.
5. Check cooling air intake screen.
6. Drain fuel/water separator.
7. Check engine drive belt.
8. Drain water out of the air tank.
9. Check for any oil or fuel leaks.
Cold Start Procedure
1. Engage the parking brake.
NOTE: Refer to “Hydrostatic Drive” provided
elsewhere in this section for further
information.
2. Turn the Ignition ON, but DO NOT engage
the starter.
(Wait for the Grid Heater ON
indicator to disappear on the Machine
Display)
.
The following warning message will appear
on the Machine Display during cold weather
conditions. Press OK (acknowledging that
you understand the engine requires a warm-
WARNING
CALIFORNIA PROPOSITION
65 WARNING
WARNING:
Diesel engine exhaust and
some of its constituents are known to the
State of California to cause cancer and
birth defects or other reproductive harm.
WARNING:
Battery posts, terminals,
and related accessories contain lead
and lead compounds, and chemicals
known to the State of California to cause
cancer and birth defects or other
reproductive harm.
CAUTION
Start engine from the operator’s seat
only. When running the engine in a
building, ensure there is adequate
ventilation.
Insufficient Cab Air Pressure Indicator
(Located on the Machine Display
Home Page - Road or Field Mode)
Summary of Contents for STS 10
Page 290: ......
