2-3
SECTION 2 –
SAFETY AND PRECAUTIONS
•
Never pour chemicals into an empty
tank. Always fill tank half full of water
first.
•
Dispose of empty chemical containers
properly.
•
Wash spilled chemicals or residue away
to prevent corrosion and deterioration.
•
Select safe areas to fill, flush, calibrate,
and clean sprayer where chemicals will
not run off to contaminate people, ani-
mals, vegetation, or water supply.
•
Never place a spray nozzle to your lips in
an attempt to unclog it.
•
Do not spray when wind is in excess of
chemical manufacturer’s recommenda-
tion.
•
Store chemicals in their original contain-
ers with the label intact.
•
Store chemicals in a separate, locked
building.
•
Wear protective equipment as recom-
mended by the chemical manufacturer.
SAFETY DECALS
Decals warning you of avoidable danger
are located on various parts of the attachment.
They are there for your personal safety and
protection. DO NOT remove them. They will
fracture upon attempted removal and
therefore, must be replaced.
Following are locations of important
safety decals. Replace them if they are
damaged or missing. All safety decals,
instructional decals, or machine striping may
be purchased through the Hagie Customer
Support Department.
To replace safety decals, ensure the
installation area is clean and dry and decide
on exact position before you remove the
backing paper.
Safety Decal Locations
30’ NTB
650137
(Located to the right of the electrical box
cover)
650219
(Located on each lower lift arm weld)
650201
(Located on each outrigger)
650204
(Located between center tool bar and
articulator)