In1
In2
TRM
702A
433.5
MHz
10 mW
IP3
0
cfg
3,5
max
In1 In2
433.5
- The device is to be installed only by a
qualified electrician in accordance with
the installation standards in force in the
country.
- Cut off the 230V power supply before
connecting the device.
The flush-mounting input module TRM702AU is a
quick
link
radio transmitter. Powered by battery,
it can be used to interface 2 floating contacts
(switches, automatic-control contacts or intrusion
alarm panel contacts) which can thus be rendered
communicating.
quick
link
radio products can be
configured together and operated within the same
radio installation.
Caption
1
Pushbutton or standard switch
2
Connector with inputs connection wires
(length 11 cm)
3
1 Battery 3V CR2430 (delivered non-
assembled)
4
Battery enclosure
5
Pushbutton and configuration LED
R
O
Do not cut the black color antenna wire and the
input wires, even if they are not used.
Features
• 2 independent input channels.
• Supply by battery.
Operation of LED
• LED flickers for 1s when pressed : the product is
not configured.
• LED goes on for 100ms after pressing: input is
configured, control is transmitted.
• LED flickers quickly for 1s after pressing: battery
is low.
• LED remains off: the battery level is too low.
Wiring, test and start-up
The modules are installed in a flush-mounting box
of 60mm diameter in association with a push-button
or a switch.
Depth will depend on the type of equipment used.
The length of connection shall not exceed 10m.
Wire not used shall be isolated.
Factory Reset
Maintain
R
pushbutton down until LED
cfg
flickers
(>10s), then release.
cfg
LED turns OFF to signal
Factory Reset end. This operation removes the entire
product configuration in any configuration mode.
After power switch-On or Factory Reset, wait for
15s before to do a new configuration.
Change of battery
Battery
3
is placed under cover
4
.
Battery change has no influence on the product
configuration.
O
These instructions for use form an integral part
of the product and must be retained by the end
user.
In1 In2
cfg
433.5
Radio transmitter flush-mounted with
battery 2 inputs
z
Technical characteristics
Supply voltage
3 V CR 2430
Battery operating life
with 10 manoeuvres
per day
Pushbutton control
> 5 years
Controlled by switch
or temperature < 0 °C
> 3 years
Transmission
frequency/ Emission
power
433,05 - 434,79 MHz
10 mW
Dimensions
41 x 39.5 x 11 mm
Max. connection
distance per input
< 10 m
Minimum contacts
closing time
50 ms
Operating temperature -10 °C —> + 50 °C
Storage temperature
- 25 °C —> + 70 °C
Degree of protection
IP 30
Receiver category 2 / Transmitter duty cycle
<10%
6LE005080D
6LE005080D
1
TRM702AU
Metal surfaces in the direct vicinity of the
product (e.g. flush mounted metal boxes)
may reduce the radio range. If necessary,
change the position of the product in the
wall box to improve the range.
Avoid the use of a metal front plate for
switches in combination with flush mounted
metal boxes.
Hager Controls hereby declares that the radio
transmitter/receiver complies with the 2014/53/
EU directive.
The CE declaration can be consulted
on the site:
www.hager.com
å
and
Complies with
IMDA Standards
DA101847
