732.28.920
HDE 17.03.21
41/52
8.1.27.
Preparation for the wall mounting:
Now lay out the enclosed spacers (thin stringers) on
the inner stair stringer.
Place them at the shortened first stair stringer
element, at the last stair stringer component and in
even distances in the middle of the staircase.
In the case of wooden stud constructions
or drywall constructions, you must set
the spacers and thus the through-holes
depending on your possible wall mounting
points (e.g. wooden stud distances of the
wall construction).
When placing the spacers, make sure that the cut-
outs of the spacers match those of the stair stringer
elements.
The spacers serve as drilling templates for the next
step.
It is ok if the lowest screw connection point has
been cut off, one screw connection at the beginning
is sufficient.
Now the through-holes for the wall installation are
predrilled. To do this, place a piece of wood or
similar under the drilling point, place the drill in the
pre-drilled hole of the spacer and drill through the
stair stringer (6mm drill).
The spacers are only screwed to the
staircase in the next step.
After you have drilled all the through holes, take the
spacers off the stairs and turn the stairs over once
so that the wall side is facing upwards.
Place the spacers back on the inner stair stringer so
that the drill holes are on top of each other.
Now screw the spacers to the stair stringer. Use the
predrilled small holes in the spacers and the supplied
3x16 Spax screws.
en
Summary of Contents for 819.50.810
Page 25: ...732 28 920 HDE 17 03 21 25 25 de ...
Page 49: ...732 28 920 HDE 17 03 21 49 52 en ...
Page 50: ...732 28 920 HDE 17 03 21 50 52 ...
Page 51: ...732 28 920 HDE 17 03 21 51 52 ...
