Adjusting and setting fence at 130 degrees
Swing the 90 degree stop out of the way.
Tilt the fence all the way back
Using 2 Squares, one with a 45 degree angle or a
compound set square,
Adjust the 130 degree stop bolt to get fence to 130
degrees, when set lock the bolt with the lock nut .
Fitting Cutter guard
Turn the spring knob about one and a half
turns counter clockwise and hold in place
Insert the cutter head guard post into the
hole in the top of the table, making sure
the spring engages in the slot in the guard
post
Check proper operation
Pull the guard out away from the fence
horizontally, then let go.
It should spring back to the fence
If it does not spring back with force
reset spring tension and check again
130 degree
stop and lock
nut
Spring knob
Cutter guard
Page 12
After setting guard tension ensure the small grub screw
is refitted to the end of shaft to stop guard being taken
out
