70
SECTION 6,
continued
location using the number keys. If a data point already has
data in it, you cannot scroll to it. Enter the desired location
with the number keys. The meter will ask if you want to erase
the current data in order to save the new data. Press
ENTER
to
accept the location and store the data. Press
EXIT
to cancel.
3. If all memory locations are full, the meter will ask to
overwrite one of the data points by displaying
Erase Sample
##?
Press
ENTER
to replace the data in that location with the
current data. Press
EXIT
to return to the previous screen
without replacing the data.
If the meter is full of data and you want to clear some
memory, send the data to a PC or printer, (see Section 7.2.3),
then erase the data (see Section 6.3.2).
4. The meter will store the reading and return to Reading mode.
6.2
Recalling Stored Data
1. To recall stored data, start in the reading mode of the
parameter of interest (pH, DO, or conductivity).
2. Press the
RECALL
key. The display will show the most
recently saved measurement data.
3. Use the arrow keys to scroll to the desired storage location, or
press
RECALL
again to retrieve a specific data point. The
question mark will flash. Enter the number of the desired
memory location.
4. Press
ENTER
to accept the memory location or
EXIT
to escape.
The sections below explain details about data from each
parameter.
