Hach sc1000, User Manual

Page: 45 / 64

45
Operation
Figure 43 Measured Value Display
5.1.4.1 Select Sensors for the Measured Value Display
1. Tap the bottom-left of the screen to display the pop-up toolbar.
2. Select the
LIST
button to view the device list of currently registered sensors
and options.
3. Select the
WRENCH
button. The display is split between the full device list and the
selected measured value display ( Figure 37 on page 41 ).
4. Select the entry in the top list and select the
ADD
button to move the entry to the
Measurement Value Display. Select the
REMOVE
button to delete an entry from the
Measurement Value Display.
5. Select
ENTER
to accept the selection. The measured value display will appear on the
screen. Depending on the number of selected values and the selected screen display
option, the user may need to scroll up or down to see all selected values.
5.1.5 Adjusting the Touch Screen Calibration
During initial commissioning of the controller, the touch screen calibration will be
automatically displayed. To configure the touch screen, follow the calibration points on
the screen. Make sure that the touch screen is calibrated to the appropriate device (finger,
stylus, etc.) that will be used by all operators. If the device is changed, it will be necessary
to recalibrate the screen.
To recalibrate the touch screen after initial commissioning:
1. From the System Setup Menu, select Display Settings and touch screen Calibration.
2. Follow the calibration points. When calibration is complete the Display Settings menu
will be displayed.
X.XX
Sensor 1
Sensor 3
Sensor 2
Sensor 4
Uhrzeit
Uhrzeit
Uhrzeit
Uhrzeit
Einheit
Einheit
Einheit
Einheit
Parameter
Parameter
Parameter
Parameter
X.XX
X.XX
X.XX
X.XX
Sensor
Time
Unit
Parameter
客服：400 688 9809
网址：www.mamots.com 电话：0431-85178766