34
Operation
5.3.1 Setting up passcode protection
The sc100 controller has a security feature to prevent unauthorised access to
configuration and calibration settings. The default passcode from the factory is
sc100_ (five characters plus space).
Section 5.3.1.1 describes how you can change the passcode.
ACTIVATE: All setting in the CONFIGURATION menu are displayed, but cannot
be changed. The CALIBRATION and MAINT. PROC. menus can be accessed
without the passcode.
DISABLED: All settings on the CONFIGURATION and CALIBRATION menu can
be changed. This is the factory setting.
Select
Menu level
Accept
1.
MAIN MENU
2.
SYSTEM SETUP
3.
SECURITY SETUP
4.
PASSCODE
5.
Mark ACTIVATE
7.
MAIN MENU or
Indication of measurement
客服：400 688 9809
