30
Operation
5.2 Controller display
The controller display indicates the current turbidity value during measurements if
a sensor is connected.
The display flashes on commissioning if
•
A sensor fault occurs
•
The "HOLD OUTPUTS" function has been activated
An active system warning results in the display of a warning icon on the right of
the display (a triangle with an exclamation mark in the middle).
Fig. 5-27
Display
1.
Status line (indicates sensor names and the
status of the relay contacts)
3.
Current output 1 or 2
5.
Area for the warning icon
2.
Main measured value
4.
Parameter
6.
Unit of measure
OUTPUT
客服：400 688 9809